Smart Controller Calibration Procedure
If the aircraft is receiving an inaccurate control response or the buttons/sticks are
unresponsive, a Smart Controller Calibration may be required.
- To begin calibration, hold both control sticks to the top left corner and (at
the same time) press the power button. The remote will beep twice per
second and the outer two indicator lights will flash.
- Rotate both sticks 360 degrees around the perimeter of each circle at
least 3 times, then release both sticks.
- Scroll the gimbal tilt wheel fully to the left, then fully to the right.
Repeat this at least 3 times.
- Press the RTH button for ~2 sec. The beeping will stop once
calibration is complete.